Stilt Gates and MS Fabrication in Kavi Nagar, Ghaziabad

When a Kavi Nagar house is rebuilt as builder floors, the ground level usually becomes stilt parking with the stair core at the back, and the whole front of the plot becomes one opening. Metal fabrication in Kavi Nagar is shaped by that change: a gate wide enough for two or three cars, used by several families, on a lane where there is little room to swing anything. The Kavi Nagar area page covers safety doors floor by floor. This page is about the stilt gate and the ground-level steel around it.

Sliding or hinged across a stilt opening?

A hinged gate across a full plot width needs leaves that swing into the stilt, where cars are parked, or out into the lane, which the lane will not allow. A sliding gate avoids both, but it needs a straight wall run beside the opening as long as the leaf. On many plots the boundary wall to one side gives exactly that; where it does not, a bi-parting slider or a hinged pair with short leaves can work.

A gate four families share

• Build a wicket door into the gate so people on foot do not open the full leaf.
• Agree the lock: one key cut for every owner, or a lock that takes a keypad later.
• Fit a stopper and a drop bolt, so a half-open leaf cannot roll into a parked car.
• Decide the design and finish together, since the gate is the face of every flat.

Sliding gates are the easiest to automate later, which suits a shared gate; the sliding gate automation guide explains what the track and the gate need. The main gate design guide has layouts for wide openings.

Steel in a narrow lane

Kavi Nagar's lanes are tight and parking is scarce, so long gate leaves are fabricated in the workshop and brought in on a small vehicle, sometimes in sections that are joined on site. The visit checks the lane, the gate posts and where a vehicle can stop. Finishing matters too: mild steel left with bare welds rusts first at the bottom track; galvanising or powder coating holds up better. For track faults, see sliding gate stuck and gate lock not working.

How the stilt gate job runs

The ₹99 visit is usually arranged within 24 to 48 hours of booking and the fee is adjusted against the final bill. The opening, the wall run, the floor level and the lane access are measured, and one written quote, all-inclusive for the agreed scope, follows within about 2 hours and stays valid for 3 days. After a 50% advance the gate, grills and doors are fabricated together; the balance is paid on completion. If owners split the bill, the quote can list each item separately.

See all styles in the metal fabrication catalogue, the MS gate price guide and MS fabrication in Ghaziabad. Flats across the Hindon in Raj Nagar Extension have their own page. Book a visit and we will measure the stilt opening.